REFLECTIVE TAPE STORE
REMOVABLE FOIL BACKED PAVEMENT MARKING TAPE AVAILABLE IN WHITE AND YELLOW IN STANDARD AND HEAVY DUTY GRADES. ITEMS SHIPPED "FAST" VIA PRIORITY MAIL OR UPS WITHIN THE U.S. Our Foil Based, removable DOT certified reflective pavement striping tape is inexpensive, durable, and easy to apply. Simply apply it to clean, dry surface and press it on. Can be removed if necessary. Designed to be used as short term striping on highways and interstates and as longer term striping in parking lots. |
HAVE A QUESTION OR NEED A SAMPLE?
CLICK TO EMAIL STEVE COLE e-mail or call me at 850-934-3157 9am-9pm |
Our 4" x 150' pavement marking tape rolls are designed to stripe asphalt & fully cured concrete parking lots, parking garages, warehouse floors, factory floors, roads and any other area where high visibility delineation is needed. Our "standard" and "heavy duty" pavement striping tapes are aluminum based, conformable and highly reflective films which are designed to provide excellent nighttime delineation during either dry or light-to-moderate rainfall. Our pavement tapes are weather resistant and provide excellent color retention. Experience has shown that our highly reflective “Standard” and “Heavy Duty Grade” tapes are generally more durable than conventional high quality paint, and will show no appreciable fading, lifting, shrinking or chipping when applied according to manufacturer’s instructions. This product can be removed by peeling it up in sections or for easier removal heat the surface of the tape with a torch or heat gun. We carry this tape in both WHITE and YELLOW in STANDARD and HEAVY DUTY grades. Our HEAVY DUTY grade is thicker and more reflective. It also contains more adhesive. INSTRUCTIONS - To install our pavement/floor striping tape simply apply it to a clean, dry surface and press it on so that it completely conforms to the surface. The temperature should be in excess of 50 degrees. Dry, clean, sun warmed asphalt or cement is ideal. Best adhesion can be achieved by going over the tape with a heavy rubber tire (dolly) roller or by using your vehicle tire. When using a vehicle be careful not to turn the steering wheel while on the fresh tape. Also, avoid applying the tape to damp asphalt or cement. Also, it is best to apply when it has not rained in 48 hours. After application the tape is ready for use, however, full curing occurs after about 48 hours and it is best if it does not rain during this time as well. I recommend you apply the tape and press it in very well. Then after 24 - 48 hours press it in again. It is always recommended that you test a couple of pieces on the surface you are going to mark and leave them down for a day or so. Holds up to traffic driving straight over it. However, twisting tires can cause it to release. (priming with contact cement will enhance adhesion) (We have tested this product with good results on smooth to relatively smooth cement and asphalt surfaces, painted surfaces where the paint is fully cured and aged, steel surfaces, and smooth wood surfaces after priming with contact cement.) CLICK HERE FOR MORE PRODUCT PHOTOS If you wish to order with a check or money order you can send payment along with a description of what you are ordering to About our products - We carry the finest quality industrial/commercial reflective tapes, non skid tapes and pavement marking tapes availble. Our parking lot striping tapes are manufactured using the highest quality raw materials that result in a durable application that is resistant to heavy traffic, water and grease. To install simply apply to a clean, dry, oil free surface and press the material firmly onto the surface. Our pavement marking tapes can be installed over most surfaces including asphalt and cement. For best results apply the tape to dry asphalt or cement when no rain is forecast. Press on using a roller or vehicle tire. |